Welcome To b2b168.com, Join Free | Sign In
中文(简体) |
中文(繁體) |
Francés |Español |Deutsch |Pусский |
| No.8064428
![](http://i.b2b168.com/e/tag_cmjz.gif)
- Product Categories
- Friendly Links
- home > Supply > Manufacturers supply pipe drilling machine (pipe drilling machine) (KA114 drill pipe) (pipe tapping machine)
Manufacturers supply pipe drilling machine (pipe drilling machine) (KA114 drill pipe) (pipe tapping machine)
Information Name: | Manufacturers supply pipe drilling machine (pipe drilling machine) (KA114 drill pipe) (pipe tapping machine) |
Published: | 2012-03-13 |
Validity: | 900 |
Specifications: | Complete |
Quantity: | 1.00 |
Price Description: | Negotiable |
Detailed Product Description: | Drill pipe Drill pipe (pipe drilling machine) (KA114 drill pipe) (pipe tapping machine) KA114-type pipe tapping machine was developed in recent years of new pipeline installation equipment, in 80 ~ 300mm of pipe holes drilled Φ25 ~ Φ114mm to reach water pipes installed in the trunk water main purpose of the branch. Machine, light weight, easy to operate, processing efficiency. Main technical parameters: spindle speed 100r.pm (no load), the largest hole saw thickness: 8mm motor power 1kw, Weight 28kg Pipe tapping machine use: 1 Plug in the power, open the motor switch, check equipment operating conditions, confirm the normal operation after the shutdown. 2, on the base of this unit V-cavalry attached to the pipe, and then adjust the length of the chain, and with the latch position, then tighten the nuts the other end of the chain, so that the unit securely positioned in the pipeline. 3, confirm the required hole diameter, clamping a suitable opening device. 4, starter motor, once again confirm the tapping machine, opening device is operating normally. 5, flip (pressure) the handle, slowly down the hole saw, close to the tube, the look is correct hole location; the other hand, should be shut down and re-adjust the position after the boot. 6, the opening, the handle under the pressure should be slowly and continuously cooled with a coolant openings. 7, opening after the end off the motor, remove the machine. Handle with care, not on the ground checked the machine. 8, the company can provide a variety of openings Contact: Cheng Ning Tel: 15053792050 0537--2886667 |
Admin>>>
You are the 53803 visitor
Copyright © GuangDong ICP No. 10089450, Mining Co., Ltd. Jining hillo All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility
You are the 53803 visitor
Copyright © GuangDong ICP No. 10089450, Mining Co., Ltd. Jining hillo All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility